NDZ Guide Rod Tool for Glock GEN 1-3

Will work with Glock Gen 1-3 models: 17, 19, 20, 20SF, 21, 21SF, 22, 23, 24, 25, 31, 32, 33, 34, 35, 37, 38.

The NDZ Performance Guide Rod Spring Removal Tool is excellent for switching out worn guide rod springs or assembly of new kits when using Stainless Steel or Tungsten guide rods. While fixing the base of the guide rod in a vise or clamp easily slip the tool over the guide rod and compress the spring to gain access to the Retaining Screw at the tip of the guide rod. Then remove the screw, and the spring to replace with another. Make sure to use a small amount of Blue (non-permanent) Loctite on the screw threads to prevent it from vibrating out loose during firing.


Note: NDZ always recommends any part be installed by a qualified and trained gunsmith. NDZ promotes the use of safety practices and gear when working on any firearm.

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.