Align Tactical Glock Gen 1-5 Tactical Trigger Pin with Thumb Rest

Gen 5 Model Fits Glock Gen 5: G17, G19, G19X, G20, G21, G22, G23, G26, G27, G34, G44, G45, G47, G49.

Gen 3/4 (Compact) Model Fits Glock Gen 1-4: G19, G23, G25, G26, G27, G28, G29, G30, G32, G33, G38, G39.

Gen 3/4 (Standard & Competition) Model Fits Glock Gen 1-4: G17, G17L, G20, G21, G22, G24, G31, G34, G35, G37, 40, 41.  

Now available at NDZ Performance the Align Tactical Thumb Rest Trigger Pin integrates an ergonomic ledge for the support hand's thumb to firmly lock down against, serving as a brake against muzzle flip to provide the fastest follow-up sight picture. Increased surface contact with the pistol reduces support hand slippage while providing an index point for a consistent high thumbs-forward grip. Swaps in seconds to offer maximum control and speed in Glock and select Glock-compatible pistols for a competitive edge. The Thumb Rest Trigger Pin utilizes a patent-pending forked design that leverages the disassembly channel's (opening) as an insertion point for accepting an anti-rotation stop. Pushing the trigger pin partially out (of an UNLOADED PISTOL), allows the anti-rotation stop to clear the disassembly channel so the slide lock can be pulled down for normal disassembly. Get one at NDZ Performance today.

Important: Glock Trigger Pins incorporate grooves that are retained by the slide stop under spring tension. Two shallow grooves are engaged by GEN 5 ambidextrous slide stops vs. a single deep groove for legacy generations. For easier pin removal, lift the slide stop to help center it to the pin grooves. Push the Trigger Pin out with a punch or use the Thumb Rest Trigger Pin itself to swap.

Note: Initial removal may require a bit of pressure. For pistol disassembly, "partially" back out the Trigger Pin to free the anti-rotation stop from the slide lock channel and rotate it clear. Push back in to re-install on a fully assembled pistol (AFTER slide is attached), to lock in place.

See our complete line of Glock Products here

Note: NDZ always recommends any part be installed by a qualified and trained gunsmith. NDZ promotes the use of safety practices and gear when working on any firearm.